Gas fireplaces come in three venting types - direct vent, vent-free and B-vent - and the venting you can run decides most of the rest. This guide walks through venting, fuel, size and controls in the order you should decide them.
1. Choose the venting type first
Direct vent
A direct vent fireplace is a sealed unit behind fixed glass. It pulls combustion air from outside and sends exhaust back out through a co-axial pipe (a pipe inside a pipe) that runs horizontally through a wall or vertically through the roof. Room air is never used for combustion, so indoor air quality is unaffected, and no masonry chimney is needed. Direct vent is the most common choice for new installs and renovations. Shop direct vent fireplaces.
Vent-free (ventless)
A vent-free fireplace burns room air and releases its combustion products into the room, so almost all of its heat stays inside. It needs no flue at all, which makes installation simple. The trade-offs: an oxygen depletion sensor is required, moisture and odor are added to the room, and maximum input and room size are limited. Some states, cities and provinces restrict or ban vent-free appliances - California is the best-known example - so check local code before you buy. Shop vent-free fireplaces.
B-vent (natural vent)
A B-vent fireplace uses room air for combustion and vents vertically through a B-vent pipe. It is less efficient than direct vent and must run vertically, so it is mostly chosen to replace an existing B-vent unit.
2. Confirm your fuel: natural gas or propane
Most gas fireplaces ship for either natural gas or propane (LP), and many can be converted with a kit. Order the version that matches your gas supply. If you have no gas line, the cost of running one is part of the project - an electric fireplace may be the simpler option.
3. Size it to the room and the wall
Two sizes matter: heat output and physical size.
- Heat output (BTU): a rough starting point is 20-30 BTU per square foot, depending on climate, insulation and ceiling height. A 20,000 BTU unit comfortably warms most living rooms; open-plan spaces call for more. See our BTU calculator.
- Viewing width and framing: measure the wall and note the framing width, height and depth listed in each product's specs. Linear units are often shallow but wide; traditional units are deeper.
4. Pick a style
- Traditional: a square or rectangular firebox with a log set - square fireplaces.
- Linear: long, low flame, often with glass media - linear fireplaces.
- See-through and multi-sided: viewable from two or three sides - see-through fireplaces.
5. Choose the ignition and controls
- Millivolt (standing pilot): needs no household electricity, so it keeps working in a power outage.
- Intermittent pilot (IPI) / electronic ignition: the pilot lights only when needed, saving gas; usually requires power or batteries.
- Remotes, thermostats and blowers: often optional; a blower moves more heat into the room.
6. List the parts you need
Most gas fireplaces need venting components sized to your run, and many need a barrier screen or decorative front. Trim kits, liners and media are often sold separately. The installation manual on each product page lists the venting limits and required parts - or ask us for a parts list.
7. Plan a professional install
Gas appliances must be installed by a licensed gas professional, and most areas require a permit and inspection. Share the installation manual with your installer before you order so the venting route and gas line are confirmed.
Frequently asked questions
Does a direct vent fireplace need a chimney?
No. It vents through a co-axial pipe through a wall or roof, within the limits in the manufacturer's manual.
Can a gas fireplace work without electricity?
Millivolt models can. Electronic-ignition models usually need power or a battery backup.
Is vent-free safe?
Vent-free units are certified with oxygen depletion sensors and are legal in many areas, but they add moisture to the room and are restricted in some jurisdictions. Check local code and follow the room-size limits in the manual.